 |
|
|
Revise your stock rear suspension and gain 1 inch in height in the rear, you will now have a true suspension.
|
|
|
|
 |
|
|
Assemble as shown, front y axle is not attached.
|
|
|
 |
|
|
Drill through rear axle as shown.
|
|
|
 |
|
|
Insert shaft into front axle from inside.
|
|
|
 |
|
|
Insert spring and washer.
|
|
|
|
|
 |
|
|
Cut off carriage in front of bearing shaft.
|
|
|
 |
|
|
Using a 3/16 drill open up hole in rear axle.
|
|
|
 |
|
|
It will be a tight fit, rod should stick out 1/8 inch.
|
|
|
 |
|
|
insert in rear y axle and attach washer and nut.
|
|
|
|
|
Completed suspension. The height of the suspension can be altered after assembly of sled by turning the nut holding the rear y axle locked.
|
|
|
